![emv card reader not working emv card reader not working](https://outoftheboxtechnology.com/wp-content/uploads/2018/05/card-reader.png)
Emv card reader not working how to#
How to check that the connection between the card reader and the computer is working? If necessary, restart your computer so that the card is properly inserted into the reader and the ID-card reader is properly connected to the computer. For the error message “ no card in card reader”, try inserting the ID-card into the reader again.have expired, act according to the instructions given by DigiDoc4! If the Digidoc4 Client shows your data, but gives you an error message or recommendation or warns you that your software, certificates, etc.How to make sure that my ID-card and card reader are working properly?Įverything is fine if the Digidoc4 Client displays your name and data after inserting the card. If turning the card to the other side does not work, insert it into the reader in such a way that the chip-end is in the front and your photo is facing downwards – check that your card is inserted into the reader as deep as possible. If you have a new ID-card reader and you haven’t used it before, try turning the card to the other side – perhaps that was the problem?ĭon’t be afraid – inserting the ID-card the wrong way will not damage it. The ID-card is inserted in most card readers with the chip-end in front in such a manner that your photo is facing downwards and the chip upwards. How do I insert the ID-card into the card reader? Read about tested and supported smart card readers. If problems emerge when you’re using your ID-card or you’re just starting to use the ID-card electronically, the first thing you should check is that everything is in order with your ID-card and the card reader.ĭon’t forget: before you start using the ID-card (or another digital document), you must install the ID-software on your computer and configure your web browsers for using the ID-card, if necessary.